Tryk2 provides good facilities for many different relief and intaglio printmaking techniques. The workshop is primarily set up to support water-based and non-toxic printing techniques, but oil-based inks can be used.

There are constant efforts to improve and expand the workshop, and at the time of writing, the following fine art printtechniques are supported: dry point, etching, aquatint, soft ground, woodcut, linocut, collography, monotypes, collageprints, xero-litografi, chine collé and of course, drawing.

Facilities
Large Flatbed Printing Press. Polymetaal (?) Land (?) 80 x 160cm

Small Flatbed Printing Press. Polymetaal (?) Land (?) 60 x 120cm
8 metres of glass-covered worktops for both clean and ’dirty’ work

Air extraction above some workspaces

Large bath for soaking of paper sheets (up to 80 x 100cm)

Drawers with different sizes for the storage of soaked paper sheets

Heating pad for lino sheets 60 x 80cm

A selection of rollers (brayers) in different sizes

Large open shelves for storage of wet prints

Large stand for the drying of relief prints
Two ??** for the raising of the workspace??

Wetroom with a large sink divided into three sections

Acid-bath 60cm high and 80cm wide with iron chloride (?) for copper (?) - adjacent to the sink

Air extractors by the sink and the acid bath

Drying cupboard

Airbrush cupboard for non-toxic aquatints
Fotopolymer lighting equipment and vacuum frame 50 x 60cm (??)

Large area with 2 good sized tables wih plenty of space for large formats, paper cutting and so on.

Soft walls for the pinning of prints, sketches and so on.

Several metal rulers and set-squares for the cutting of paper and so on.

Hand-held mount cutter with a maximum 122cm edge.

Plate cutter for copper plates, with a maximum 67cm edge.

Print cradle, 50 x 100cm

Photocopier